Private Internet Access with OpenVPN: Difference between revisions
No edit summary |
No edit summary |
||
| Line 27: | Line 27: | ||
p123456 | p123456 | ||
asw34fds34 | asw34fds34 | ||
</pre> | |||
Secure login file | |||
<pre> | |||
chmod 600 /etc/openvpn/login | |||
</pre> | </pre> | ||
| Line 46: | Line 51: | ||
If all good enable services on startup. | If all good enable services on startup. By default all VPN config files will start. If only using a single VPN then ignore these section. | ||
<pre> | <pre> | ||
systemctl disable openvpn | |||
systemctl enable openvpn@sydney | systemctl enable openvpn@sydney | ||
</pre> | </pre> | ||
| Line 62: | Line 68: | ||
If you want to set this device as a router so the other devices on your network can now use the VPN tunnel change the gateway on all your devces to look at this device and make the following changes. | |||
To allow the device to NAT traffic over the VPN. | To allow the device to NAT traffic over the VPN. | ||
| Line 78: | Line 85: | ||
</pre> | </pre> | ||
You may also be interested in [[SOCKS Proxy]] | |||
[[Category : Debian]] | [[Category : Debian]] | ||
Revision as of 23:48, 30 April 2019
Install OpenVPN
apt -y install openvpn
Download PIA Config Files
wget https://www.privateinternetaccess.com/openvpn/openvpn.zip -O /tmp/openvpn.zip
Extract Config Files
unzip /tmp/openvpn.zip -d /opt/openvpn cp /opt/openvpn/AU\ Sydney.ovpn /etc/openvpn/sydney.conf cp /opt/openvpn/ca.rsa.2048.crt /opt/openvpn/crl.rsa.2048.pem /etc/openvpn/
Create Login File
vi /etc/openvpn/login
Add your username and password to this file. Line one is your username and line two is the password
p123456 asw34fds34
Secure login file
chmod 600 /etc/openvpn/login
Update the config file to use your username and password rather than prompting.
sed -i 's/auth-user-pass/auth-user-pass \/etc\/openvpn\/login/' /etc/openvpn/sydney.conf
Does the service run
openvpn --config /etc/openvpn/sydney.conf
Open another session and verify IP address
curl ifconfig.co
If all good enable services on startup. By default all VPN config files will start. If only using a single VPN then ignore these section.
systemctl disable openvpn systemctl enable openvpn@sydney
If you have a public IPv6 address disable IPv6
cat >> /etc/sysctl.conf << EOF #Disable public IPv6 address net.ipv6.conf.all.disable_ipv6 = 1 EOF
If you want to set this device as a router so the other devices on your network can now use the VPN tunnel change the gateway on all your devces to look at this device and make the following changes.
To allow the device to NAT traffic over the VPN.
iptables -A POSTROUTING -o tun0 -s 192.168.1.0/24 -t nat -j MASQUERADE
Show Tables
iptables -t nat -nvL
Delete Tables
iptables -t nat -F
You may also be interested in SOCKS Proxy
