Wi-Fi for Raspbian: Difference between revisions
From KlavoWiki
Jump to navigationJump to search
No edit summary |
No edit summary |
||
Line 25: | Line 25: | ||
<pre> | <pre> | ||
scan | scan | ||
</pre> | |||
wait about 15 seconds for the scan to complete | |||
</pre> | |||
scan results | scan results | ||
</pre> | </pre> |
Revision as of 09:09, 9 August 2014
Check if Raspbian can see the USB device.
lsusb
the result should be something like
Bus 001 Device 002: ID 0424:9512 Standard Microsystems Corp. Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 001 Device 003: ID 0424:ec00 Standard Microsystems Corp. Bus 001 Device 004: ID 0bda:8176 Realtek Semiconductor Corp. RTL8188CUS 802.11n WLAN Adapter Bus 001 Device 005: ID 05e3:0608 Genesys Logic, Inc. USB-2.0 4-Port HUB Bus 001 Device 006: ID 05e3:0608 Genesys Logic, Inc. USB-2.0 4-Port HUB Bus 001 Device 007: ID 4971:1020 SimpleTech
You can see my Wi-Fi device as device number 004.
Run the following commands
wpa_cli
from within this cli use the following commands
To view the current SSID's within range
scan
wait about 15 seconds for the scan to complete
scan results
Configure the required SSID
add network set_network 0 ssid "ssid-name" set_network 0 psk "psk-password" enable_network 0 save_config quit
Check for configuration
iwconfig
By default the interface will use DHCP to get an IP address. If you wish to assign a static IP address to wlan0 refer to Static_IP_Address_for_Raspbian
Here is a reference for my configuration
/etc/wpa_supplicant/wpa_supplicant.conf
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev update_config=1 network={ ssid="ssid-name" psk="psk-password" }