Swapfile: Difference between revisions
From KlavoWiki
Jump to navigationJump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
= Raspberry Pi = | |||
== Remove Swapfile == | |||
<pre> | |||
dphys-swapfile swapoff | |||
dphys-swapfile uninstall | |||
</pre> | |||
Remove dphys-swapfile application and dependency | |||
<pre> | |||
apt-get purge -y dphys-swapfile dc | |||
</pre> | |||
= Banana Pi = | |||
I've written this based on my experience of Bananian which is Debian based. | I've written this based on my experience of Bananian which is Debian based. | ||
= Deleting Swap File = | == Deleting Swap File == | ||
<pre> | <pre> | ||
swapoff /swapfile1 | swapoff /swapfile1 | ||
| Line 11: | Line 25: | ||
= Creating Swap File = | == Creating Swap File == | ||
== Hard Disk Partition == | === Hard Disk Partition === | ||
The parition needs to be created as a swapfile and not ext3, ext4 or something else. | The parition needs to be created as a swapfile and not ext3, ext4 or something else. | ||
<pre> | <pre> | ||
| Line 19: | Line 33: | ||
</pre> | </pre> | ||
== File == | === File === | ||
Create a file of 1GB | Create a file of 1GB | ||
<pre> | <pre> | ||
| Line 28: | Line 42: | ||
</pre> | </pre> | ||
= fstabs = | == fstabs == | ||
<pre> | <pre> | ||
vi /etc/fstab | vi /etc/fstab | ||
| Line 44: | Line 58: | ||
= swapiness = | == swapiness == | ||
<pre> | <pre> | ||
vi /etc/sysctl.conf | vi /etc/sysctl.conf | ||
| Line 75: | Line 89: | ||
</pre> | </pre> | ||
[[Category : Banana Pi]] [[Category : Linux]] | [[Category : Raspbian]] [[Category : Banana Pi]] [[Category : Linux]] | ||
Revision as of 10:04, 20 August 2016
Raspberry Pi
Remove Swapfile
dphys-swapfile swapoff dphys-swapfile uninstall
Remove dphys-swapfile application and dependency
apt-get purge -y dphys-swapfile dc
Banana Pi
I've written this based on my experience of Bananian which is Debian based.
Deleting Swap File
swapoff /swapfile1
rm -f /swapfile1
Creating Swap File
Hard Disk Partition
The parition needs to be created as a swapfile and not ext3, ext4 or something else.
mktemp /dev/sda1
File
Create a file of 1GB
dd if=/dev/zero of=/swapfile1 bs=512 count=2048 chmod 600 /swapfile1 mkswap /swapfile1 swapon /swapfile1
fstabs
vi /etc/fstab
Add an entry or change the existing one
/dev/sda1 swap swap defaults 0 0
or
/swapfile1 swap swap defaults 0 0
swapiness
vi /etc/sysctl.conf
vm.swappiness Values
| Value | Strategy |
| 0 | The kernel will swap only to avoid an out of memory condition, when free memory will be below vm.min_free_kbytes limit. See the "VM Sysctl documentation". |
| 1 | Kernel version 3.5 and over, as well as Red Hat kernel version 2.6.32-303 and over: Minimum amount of swapping without disabling it entirely. |
| 10 | This value is sometimes recommended to improve performance when sufficient memory exists in a system. |
| 60 | The default value. |
| 100 | The kernel will swap aggressively. |
After reboot check current value
cat /proc/sys/vm/swappiness
